MOC – Lego Technic – TRIUMPH Scrambler [instruction]

5,00

  • Parts zip file
  • PDF photos sequences

Description

lego_technic_motorycle.com_bandeau_mechancinal
  • Bicylinder in line engine
  • 900 cc
  • rear suspension

 

lego_technic_motorycle.com_bandeau_story

Legotechnicmotorcycle presents you a creation by moc-nemooz of Lego Technic – TRIUMPH Scrambler

The Scrambler was designed as a Bonneville with off road styling and limited off road capability.

The TR6C Trophy Special was the major influence on the new Scrambler, and the new bike shared the same key features – most obviously including the high level stacked twin exhausts and crossover exhaust headers, though Triumph had to swap sides (from left to right) with the stacked pipes because the battery box got in the way for running them on the left hand side.

The Scrambler also featured a high, wide handlebar, a higher seat position, twin chromed Kayaba rear shock absorbers (with increased 106 mm travel), 41 mm Kayaba front forks with 120 mm travel and rubber fork gaiters, a small single headlight with a simple speedo, and chunky, knobbly Bridgestone tyres on the thin 36-spoke 19 x 2.5-inch front wheel and the 40-spoke 17 x 3.5-inch rear wheel.

A whole range of Triumph Factory accessories was designed for the Scrambler, including a skid plate to protect the underneath of the engine, engine bars, a headlamp grille, number boards for the sides, an optional tachometer on early models (twin side by side speedometer and tachometer became standard from 2010 model year), a handlebar brace and pad, and even a single seat with fixed rear luggage rack behind. A popular aftermarket addition is a two-into-one performance exhaust system from Arrow.

The engine was the 865 cc parallel twin from the Bonneville (but using the 270° crank from the America/Speedmaster cruiser models) with twin carburetors, detuned to boost torque at low engine speeds, with peak power 54 hp (40 kW) at 7,000 rpm, and maximum torque of 69 N⋅m (51 lbf⋅ft) available at 5,000  rpm. Multipoint sequential electronic fuel injection with SAI was introduced in 2008 (2009 in the USA) necessitating the fitting of a larger fuel tank that housed the new pump unit. Throttle bodies were disguised to look like carburetors to maintain the Scrambler’s retro looks.

lego_technic_motorycle.com_bandeau_video

Reviews

There are no reviews yet.

Be the first to review “MOC – Lego Technic – TRIUMPH Scrambler [instruction]”

Related Posts

Begin typing your search term above and press enter to search. Press ESC to cancel.

Back To Top